I have a KV32FX66B , If you switch it to standby and then switch it back on ( within 5 to 10 min) it does not come on it gives 5 blinks. I have to wait for approx 30 min and then it will switch on OK. However I have adjusted the Screen G2 voltage on the flyback transformer ( after some research in here) and now the TV will switch on and off without problem , but I have light flyback lines on the screen. No matter how delicatly I adjust the screen(G2) voltage I am unable to get it to both clear the flyback lines and switch on and off. I am no expert with TV's but I was considering ordering a new flyback transformer and replacing it . What do you think ??? , is this worth a try or is it more likley to be something else ??
Thanks in advance.
One more point , if I plug the TV out over night then the next morning it will switch off and on ok, but if I let it heat up and switch it off and on the problem reoccurs.
I have also noticed a green dot in the centre of the screen as the tube is switching off, is this a sign of a tube on its way out ?
Would you completley rule out the flyback trafo.
All logos and information in this site are property of their respective owner. The
comments are property of their posters.
This website www.agoraquest.com, Claudio Meira and Agoraquest, LLC is not tided in any form to the Sony Corporation
(www.sony.com). This unoffical website is just place where Sony products are reviewed among the general public. Sony is a registered
of Sony, Inc. "PlayStation", "PlayStation2", the PlayStation "PS" logo, and all associated logos/graphics.
"Agoraquest, LLC" and "agoraquest.com" are associated exclusively with agoraquest.com, and are NOT associated in ANY way with Sony
please click here. If you have any further questions, please contact using our online form.