I do not have a HS10 but do have the service book for the HS30...Diagnosis is:H,out(Q8024) is shorted. D board....+B PWM (Q8035, 803 is shorted. D board. Detected Symtoms...Power does not come on. Diagnosis item...+B overcurrent (OCP). It looks like you have a short on a transister on the D board. Which would be the first board to the left of the chasis, on the top, when you are at the rear of the set. More that likely you'll have to get a new D board.
I recently purchased this model and would like to perform a convergence on the set. I have a 61hs30 rear projecter which when converged is simply stunning. The 36hs510, is still under warranty but I find that techitions do not have the patience to do a proper convergence. Thanks.
I followed some of the suggestions that I've seen on this forum to reduce the red push on the 510. All I can say is that you should write down the default factory settings so that you can revert to them if needed. I found that the picture was better with the factory settings. I started seeing that the picture was green at start up and that the tint was off. I have both satellite and cable. The picture is better with the satellite, cable looks too harch. I just recently bought the HD converter for the x-box and dvd movies look very good.
All logos and information in this site are property of their respective owner. The
comments are property of their posters.
This website www.agoraquest.com, Claudio Meira and Agoraquest, LLC is not tided in any form to the Sony Corporation
(www.sony.com). This unoffical website is just place where Sony products are reviewed among the general public. Sony is a registered
of Sony, Inc. "PlayStation", "PlayStation2", the PlayStation "PS" logo, and all associated logos/graphics.
"Agoraquest, LLC" and "agoraquest.com" are associated exclusively with agoraquest.com, and are NOT associated in ANY way with Sony
please click here. If you have any further questions, please contact using our online form.