Currently Listing 20 Search Results
To view all
18 results. You must be an Agoraquest member with over 100 posts or a Premium Member. It's free to register and to
upgrade to Premium Membership is only $12 per year. Also there are several incredible benefits with Premium Membership
including access via Private Messaging to our top
members.
To view benefits, screenshots and how to upgrade easily to premium membership by clicking here
|
| Forum |
Topic |
Author |
Replies |
Posted |
| Television Troubleshooting | Sony KP-FX532 Projection Blinking 10 Times. No picture only sound | tobataufik | 3 | 2009-06-11 13:28 |
| First 650 characters of this post | My Sony Projection TV KP-FX532M91 blinking red 10 times after that wait 3 second andblinking again 10 times continues. if i try to turn on the tv it hassound but no picture after 10 second it turn off automatic to standby.If i unplug the power cable more than 5 hours and try it on the tvworks normally picture and sound good (still blinking red but the tvworks normally) but if i turn off the tv the problem came againblingking red 10 times and can't on again......... Anybody can Help... Thnx[ This message was edited by: tobataufik on 2009-06-11 13:31 ] |
| Television Troubleshooting | KV-40XBR700 sound no picture | pells61 | 1 | 2008-12-30 13:22 |
| First 650 characters of this post | Model: KV-40XBR700 Manufactured:September 2001 DX-1A Hello all, my Sony 40' XBR700 is on the fritz. A few weeksback I shut off my TV only to find once I turned it back on it had no picturebut it did have sound. Once unplugged fora few days I tried the set again and I had everything back picture and all untilI tried to cycle the power. Once power was turned off then back on same symptoms.I have done some research and this is the phys |
| Television Troubleshooting | sony lcd kdl-42 | claudio | 7 | 2008-06-25 13:06 |
| First 650 characters of this post | Is it the KDL-42XBR950?MODEL: KDE42XBR950, KDE50XBR950, KDE61XBR950, KDL32XBR950, KDL42XBR950, KE42XBR900, KE50XBR900, KLV30XBR900, LDM3000, LDM3210, LDM4210, MBDXBR950, MBDXBR950L, PDM4200, PDM4210, PDM5000, PDM5010, PDM6110SUBJECT: Diag CodesCAUSE: What are the definitions of the diagnose codes?RESOLUTION: If the MRU Blinking 10 Times - Over Voltage Problem,MRU Blinking 9 times and Display section LED is flashing RED/GREEN, RED/ GREEN - Plasma Panel or plasma Circuit boards are at fault.MRU Blinking 9 times and D |
| Frequently Asked Questions for Sony Products | Television Troubleshooting Information Packages | jehill | 2 | 2008-02-27 18:01 |
| First 650 characters of this post | Member jehill has graciously volunteered to email members a package from the list below in response to a private message (PM). The packages typically include excerpts from the applicable Sony service documents. Members my obtain a package by going to their Inbox at the bottom of the left column and sending jehill a PM containing the Package Title/Applicability and their email address. DON'T FORGET TO INCLUDE YOUR EMAIL ADDRESS IN YOUR PM! This will eliminate unecessary delay for you and time |
| Frequently Asked Questions for Sony Products | What do the Sony Television Blinking Codes mean? | claudio | 2 | 2008-02-18 13:22 |
| First 650 characters of this post | Understanding Sony Television Blinking Codes Many of the later model Sony TV’s have a built in self-diagnosis function. If the timer/standby indicator is blinking, this could be an indication of a problem with the unit. The diagnostic blinking will occur automa |
| Television Troubleshooting | 2 blinks -- kp53hs10 | ukcat1972 | 4 | 2008-01-16 10:26 |
| First 650 characters of this post | On 2008-01-13 19:34, ukcat1972 wrote: Need help with kp53hs10. When I plug it in I hear it click but all I get is the standby light blinks in the 2 blink sequence. Sometime when I plug it in I get the standby light blinking constantly. Does anyone know the code for 2 blinks, and/or the repairs needed. Seems like no one has info on this model TV. Anyone have a service manual they could email me? |
| Television Troubleshooting | KV-24FV12 Troubleshooting Help | racingiron | 7 | 2008-01-13 16:00 |
| First 650 characters of this post | I've got a Sony KV-24FV12 that croaked the other day. When turned on (with remote or front panel), a rapid succession of clicks (7 or 8) can be heard then after a few seconds of normal standby LED blinking it will power off. There's never a picture or sound, and I've left it unplugged for several hours with no change. I get blink codes from the standby light after it powers off. Usually it blinks four times first, then repeats five blinks indefinitely. I presume this means I have code 4 and 5 in succession. Sometimes I'll just |
| Television Troubleshooting | Another XBR400 Gone!! | Ra | 9 | 2007-10-13 16:14 |
| First 650 characters of this post |
On 2007-10-13 02:31, ntehicks wrote:When I first started on my KV32XBR400 it had 5 blinks. I took the back cover off and looked at the board on the back of the CRT. I found that IC9001 part number TDA6111Q Had a burn through on it. I replaced this part and then the TV would turn on as it warmed up the sound would come on for about 2 |
| Television Troubleshooting | sony kp-46wt510 blinks 4 times | faceface | 1 | 2007-09-25 00:57 |
| First 650 characters of this post | I have a Sony projection TV KP-46WT510, when the set is turned on thestandby light blinks four times. I have replaced IC8003(LA78045). (theboard number is A1302708A)After replacing the IC I am still experiencing the same problem as thestandby light is still blinking four times. I am asking if you canassist me with the problem and a service manual will be greatlyappreciated. thanks in advance. |
| Television Misc and News | Sony KV-32FS13 5-blink prob, picture flashes unless color temp set to "warm"! | jki69 | 2 | 2007-05-08 09:45 |
| First 650 characters of this post | I have a strange problem that just developed with my Sony KV-32FS13 Trinitron: the audio stays fine, but the picture blanks out to black for a second or two every couple of seconds, and then comes back.
the front timer/standby light blinks five times, pauses, and starts blinking again. This blinking does not stop no matter what I do, turn the TV off, unplug it for a couple of hours, etc.
The very strange thing is that if I change the picture mode(?) to MOVIE, which has a color temp of WARM, the flashing stops, and the video picture works fine. If I switch to VIVID, SPORTS, |
| Television Troubleshooting | KV-32FQ70 E 8 blinks problem | Beauman | 5 | 2007-01-10 17:00 |
| First 650 characters of this post | Hope this helps!Sony TV Blinking Codes & What It Means When the Standby/Timer Light Flashes Sony problem:Unit is dead, No blinks - Problem in the standby power section. Might check fuse, R607, Q601, IC601, R612 and VDR601 (should show open).Continuous blink once a second, no pausing - No reply from the jungle IC301 (data bus is busy, shorted to ground, or held high), IK video path is defective.
One blink - not used for the self-diagnosis
Two blinks - B+ over current protection (OCP), unit goes to the |
| Television Troubleshooting | KV-30HS420 6 Blinking lights | basicsroc | 6 | 2006-11-13 04:39 |
| First 650 characters of this post | Hello,
I have had my KV-30HS420 for about a year now. Today it died and now the standby light is blinking 6 times in between pauses. Ocassionally it does 7 blinks.
I had only been watching tv for about 20 minutes.
Any insight on this would be immensely appreciated.
-Thank you[ This message was edited by: basicsroc on 2006-11-13 16:33 ] |
| Television Troubleshooting | kdf problems.... bigtime | jehill | 5 | 2006-03-19 11:23 |
| First 650 characters of this post | Welcome to Agoraquest! Is it the STANDBY/POWER LED that blinks four times? If so, that indicates, \"Fan stopped\". The probable causes listed are as follows?1) Fan 1-4 power is not supplied (AGU board)2) Fan connector is not attached securely.3) Fan caught wires or harnesses.There are at least two fans in the set. Are you sure that you have the number of blinks correct? Is the LAMP LED on or blinking?If you live in the US, you may purchase board part number A1113732A $124.21 |
| Television Troubleshooting | KV-29X5E "green screen trouble" | Borabora | 3 | 2005-07-05 13:51 |
| First 650 characters of this post | Hello,when the screen becomes entirely green (or red or blue) and the TV shuts off with a blinking standby-LED, the cause will be an internal short between one of the cathodes and the heater of the picture tube.To cure this, the picture tube has to be replaced. Due to the high cost, this is seldom done for a set of this age.So far the bad news: There is an unofficial workaround which can be tried. Because the heather circuit is connected to ground, in case of heather/cathode short the cathode will be grounded too. This causes excessive beam current in t |
| Television Troubleshooting | KV32XBR400- D-board Replaced- Now Blurry side Picture | saboveed | 5 | 2004-11-07 16:43 |
| First 650 characters of this post |
I had my D-board replaced and now I have a blurry picture. The tech came back and said that the EPPROM chip is not part of the d-board which was replaced. He said that the epprom is on another part of the set. He played with the adjustments but was unable to correct the problem and now claims it has nothing to do with my D-board, that\'s when I hit the roof.The new problem is that the side edges of the screen are slightly blurry for the first |
| Television Troubleshooting | KV32XBR400- D-board Replaced- Now Blurry side Picture | saboveed | 1 | 2004-11-07 16:43 |
| First 650 characters of this post |
I had my D-board replaced and now I have a blurry picture. This is a new thread since the subject is a little different.The tech came back and said that the EPPROM chip is not part of the d-board which was replaced. He said that the epprom is on another part of the set. He played with the adjustments but was unable to correct the problem and now claims it has nothing to do with my D-board, that\'s when I hit the roof.The |
| Television Troubleshooting | KV-E2953E going off with blinking A B LED's (code?) | poldemol | 2 | 2004-03-28 11:25 |
| First 650 characters of this post | This TV is 10 years old, still working perfect (until today).It has been going into standby mode a few times today and the Stereo LED\'s are blinking as follows when this happens:first 13 times blinking B-LED, then 1 x A-LED& this keeps repeatingSwithing it back on works but the same procedure happens again sometimes. Any idea\'s about this diagnostic code?Thanks in advance. |
| Television Troubleshooting | My Sony KV-X2962U Television | Ninio | 10 | 2002-10-31 07:56 |
| First 650 characters of this post | Apologies for the spliced/multiple postings...just trying to keep things in perspective
Regarding the instant random blank screen problem…
--------------------------------------------
CHASSIS AE2 (This is our model\'s chassis)
id:= 014077
Picture intermittently blanks out then shuts down and restarts
-Loss of field output due to dry joints on the field output chip (next to l.o.p.t by back panel)
id:= 014073
Front led flashing 13 times, field problems
-Replaced the field IC TDA8179 with a STV9379, also replaced the 0.47ohm resistor at pin 7 of |
