Displaying results 0 to several of several search results
You can view the first 3 pages (30 results). To view all
several results. You must be an Agoraquest member with over 100 posts or a Premium Member. It's free to register and to
upgrade to Premium Membership is only $12 per year. Also there are several incredible benefits with Premium Membership
including access to over 4,000 service manuals, faster post response and access to Private Messaging our top
members.
To view benefits, screenshots and how to easily upgrade to premium membership by clicking here
|
| Page Number: |
| Forum |
Topic |
Author |
Replies |
Posted |
| | | 0 | |
| First 650 characters of this post | |
| Television Troubleshooting | kdl-46hx800 3d tv turns off then blinks 7 times | jehill | 6 | 2013-06-11 11:22 |
| First 650 characters of this post |
Welcome to Agoraquest! For the KDL46HX800, 7 blinks, pause, 7 blinks, etc. means \"Temperature Error\" and the possible location listed is \"BAL Board\".This is the starting point for a qualified service technician. |
| Television Troubleshooting | KDL46HX820 4 blinks | bobstvaz | 2 | 2013-04-05 16:05 |
| First 650 characters of this post | I have a KDL46HX820 that picture comes on for about 5 seconds then shuts down with 4 red blinks. Backlights? |
| Television Troubleshooting | KDL-46BX420 not turning on, no LED blinking | jehill | 10 | 2013-03-24 14:16 |
| First 650 characters of this post | I don\'t have access to the KDL46BX420 service manual, but I can tell you that the white box that is clicking is an RY (relay), not a R (resistor). I wouldn\'t replace all of the electrolytic capacitors, but I might try replacing the power supply board. Its the board that the power cord goes to and usually starts with the letter G as in G1, G2, etc. |
| Television Troubleshooting | KDL52W3000 no power, no lights, no codes | jehill | 11 | 2013-03-19 13:51 |
| First 650 characters of this post | I don\'t have access to the KDL52W3000 service manual, but I do have access to the KDL46W3000 service manual. According to that manual, the power cord is connected to the GF1 board. If the information in the link that you provided is correct, it would be the GF2 Power Supply board in your set. If you are planning on replacing one board at a time, that\'s where I would start. |
| Television Troubleshooting | Sony KDL-46VL160 presents only vertical stripes | modeltdriver | 4 | 2013-03-12 11:11 |
| First 650 characters of this post | The TV came with a two year warranty, which is unusual (typical is a year) and that was one of the reasons we chose it. This is the warranty: http://www.docs.sony.com/release/Warranty_4144388011.pdfI'll share what Sony emailed via their "sonylistens" Advanced Resolution Team:"Unfortunately as much as Sony attempts to provide a perfect product that will last for many years, sometimes repairs are required..... Since your unit is now out of warranty and in fairness to all Sony cus |
| Television Troubleshooting | can I fix this TV? - two year old KDL-46xbr9 - blink code 13 then 14 | jehill | 6 | 2013-03-03 13:45 |
| First 650 characters of this post | For the KDL46XBR9,13 blinks, pause, 13 blinks, etc. of the red standby light means \"Balancer\" and the possible locations listed are as follows: LCD Panel, D1N Board (inverter) and D2N Board (inverter)14 blinks, pause, 14 blinks, etc. of the red standby light means \"TCON Err\" and the possible location listed is \"LCD Panel\".These are the starting points for a qualified service technician. If the 14 blinks code repeats, that\'s the code that I would go with. The TCON board is attached to the rear of the LCD and MAY have a fuse on it. I would look for th |
| Television Troubleshooting | SONY KDL46HX800 INTERNEL TEMPERATURE ERRORS | CHARGER72 | 6 | 2013-02-24 20:44 |
| First 650 characters of this post | Hi,I am wondering if anyone has had any experience with internal temperature errors with this model or similar models.The set will turn on and run for anywhere between 5min to a few hours. After it shuts down and gives the temperature error code it may take a day or so before it turns back on. I have got the by Vid-Saver" href="http://www.avsforum.com/t/1459859/sony-kdl46-hx800-internal-temperature-errors-7-flashes#">service manual on from an online source. I |
| Amp/Receiver/Speakers/Connections/Cables | Sony SS-X high definition speakers | jfbar1a | 69 | 2012-12-13 18:40 |
| First 650 characters of this post | Looking at the picture from above, from the left is my TAE/N9000ES combo. I use the TAE for my Direct TV and music via the VLink USB asynchronous DAC (Thanks for turning me on to that MAX!) . In the center is my (stillborn) HTPC, Toshiba XA2 HDDVD (RIP) and Direct TV box. Very frustrating on that HTPC. I have been building them for over 10 years and thought I had seen it all as far as operating system installation and troubleshooting. But this latest build will NOT run Windows7 properly. Something in the hardware (I think CPU |
| Television Troubleshooting | KDL46V4100 - Ghosting / Lines / Blur | Berserk87 | 7 | 2012-11-15 03:45 |
| First 650 characters of this post | Hi guys, I just recently received a kdl46v4100 from my parents.The problem is I get really bad ghosting, lines all over the place, and the colors all messed up, usually the right side of the screen is blacked out.After letting it sit for 10-15 minutes it clicks back to normal.Heres a vid I took a while ago |
| Television Troubleshooting | KDL-46XBR9 power surge | jehill | 8 | 2012-11-14 16:09 |
| First 650 characters of this post | I am not so sure that the service manaul will help you much, but if you send me (jehill) a privated message (PM) requesting it, I will send it to the email address that you specify.For the KDL46XBR9, 14 blinks, pause, 14 blinks, etc. means "TCON Err" and the possible location listed is the LCD panel.The LCD panel includes the TCON board. If the serial number for your KDL46XBR9 is in the range 3,000,001 - 3,100,000, the TCON board part number is A1653703A. If the serial number is in the range 3,100,001 - 3,200,00, the TCON board is not available. The |
| Page Number: |
